Scania TMS DTC 2767 Coupling sleeve (G3), no movement from engaged to disengaged position

TMS Transmission Management System · Scania

Code 2767 (decimal). Some diagnostic tools show it in hexadecimal as 0ACF.

In short

The position sensor indicates that coupling sleeve (G3) has not moved from the engaged to disengaged position even though the solenoid valve has been activated.

Applies to: TMS4 (TMS)

What does Scania TMS fault code 2767 mean?

What causes Scania DTC 2767?

Sit check sensor lorem circuit dolor unit amet voltage valve ipsum signal sit check sensor lorem circuit dolor unit amet voltage valve ipsum signal sit check sensor lorem circuit dolor unit amet voltage valve ipsum signal sit check sensor lorem circuit dolor unit amet voltage valve ipsum signal sit check sensor lorem circuit dolor unit amet voltage valve ipsum signal sit check sensor lorem circuit dolor unit amet voltage.

How does the system react?

How to fix Scania TMS fault code 2767?

Read the full explanation with Premium

Causes, system reaction, symptoms and step-by-step repair instructions for every fault code are available to Premium members.

Full explanations of every code and brand
Causes, symptoms and repair steps
New brands and codes included

Get Premium – 7,50 € / month I already have an account

Yearly plan: pay 10 months, get 12. Cancel at any time.

This information is for guidance only. Always follow the manufacturer workshop manual and safety procedures; if in doubt, contact an authorised workshop.