Scania fault code 834

EMS Engine Management System Camshaft position sensor T135 The control unit indicates a short circuit to earth in the cable harness of the camshaft position sensor. Read explanation → BMU Battery Management Unit The wear counter for the contactor unit, implausibly high Loss of voltage supply to the IBU unit when the electric drive system is active sets the contactor unit wear counter to maximum value. Read explanation → EMD Camshaft position sensor T135 The camshaft position sensor is shorted to ground. Read explanation → EME Camshaft position sensor T135 The camshaft position sensor is shorted to ground. Read explanation → EMO Camshaft position sensor T135 The camshaft position sensor is shorted to ground. Read explanation → VDT Gearbox oil Gearbox oil level too high. Read explanation → COO Coordinator CAN communication with switch module Fault in communication with the switch module. Read explanation → MBS #Not implemented. Defroster valve defective Feedback sensor is out of range or short circuit in flap control. Read explanation → PCS CAN message missing Messages have not been received within 5 nominal transfer rate periods. Read explanation → CMS Solenoid valve for tag axle lifting bellows, short circuit to earth Solenoid valve for tag axle lifting bellows, PWM output 4 (pin A18), is short-circuited to earth. Read explanation → DCC Low voltage in the direct current converter E84 on the voltage class B side Voltage class B to the direct current converter is too low. Read explanation →