Scania fault code 817

EMS Engine Management System Knock sensor Knock sensor 2 produces deviating value. Read explanation → BMU Battery Management Unit The voltage is too high in the direct current converter E84 (DCC) on the voltage class B side It has been detected that the voltage is too high on the cable harness with voltage class B. Read explanation → COO Coordinator Steering angle sensor The voltage supply to the steering angle sensor is too low and may be short circuited to earth. Read explanation → MBS #To be removed, DTC 0330 updated to cover both 330 and 331 Climate system does not make cool. Read explanation → PCS CAN message missing The sequence check does not match the number of messages received. Read explanation → CMS Solenoid valve for rear axle, left-hand side The voltage on the output to the solenoid valve (control unit pin A30) has been too high. Read explanation → DCU Door control unit, door position sensor 2, recurring faults The door control unit has detected that the supply voltage to the door position sensor is outside of the valid voltage range (0.8-10.6 V). The fault has lasted for less than ½ seco… Read explanation → DCC The voltage is too high in the direct current converter (DCC) on the voltage class B side It has been detected that the voltage is too high on the cable harness with voltage class B. Read explanation →