Scania fault code 816

BMU Battery Management Unit Internal hardware fault for direct current converter E84 (DCC) An error message has been sent from the direct current converter. Read explanation → COO Coordinator Steering angle sensor The steering angle sensor is short-circuited to voltage. Read explanation → MBS Cooling system for driver area, the pressure is too low or too high The climate system sensor indicates too low or too high a pressure. Read explanation → PCS CAN message missing The number of received messages does not match the control number. Read explanation → CMS Solenoid valve for operating air to the rear axle Open circuit from control unit pin A27. Read explanation → DCU Door control unit, door position sensor 1, recurring faults The door control unit has detected that the supply voltage to the door position sensor is outside of the valid voltage range (0.8-10.6 V). The fault has lasted for less than ½ seco… Read explanation → DCC Direct current converter, measurement failure, or internal hardware failure An error message has been sent from the direct current converter. Read explanation →