Scania fault code 568

VDT CAN bus Invalid CAN message Permissible time for the PWM signal has been exceeded. Read explanation → COO Coordinator Communication with the suspension management system Communication between the coordinator and the suspension management system is interrupted. Read explanation → MBS #Not implemented. Short circuit on rear view mirror heating output, right side Short to supply evaluated cyclically when output is inactive. Short to ground evaluated cyclically when output is active. Voltage at pin out of valid range. Read explanation → BCI Excess current, C259-14 Excess current or short circuit to ground or supply voltage. Read explanation → ACS Articulation Control System Vehicle speed, implausible value Signals from the tachograph and brake management system indicate different values for vehicle speed. Read explanation → EST Caster-steered fault mode A fault in the tag axle steering system has brought about a degradation to caster-steered fault mode. This fault code is active until the root cause of the fault has been actioned… Read explanation → ESTA Caster-steered fault mode A fault in the tag axle steering system has brought about a degradation to caster-steered fault mode. This fault code is active until the root cause of the fault has been actioned… Read explanation → ACSX Vehicle speed, implausible value Signals from the tachograph and brake management system indicate different values for vehicle speed. Read explanation →