Scania fault code 19

EMS Engine Management System Fault in 2 temperature sensors in the exhaust gas aftertreatment system. The engine control unit indicates that there are faults in 2 temperature sensors in the exhaust gas aftertreatment system. Read explanation → VDT Rotational speed sensor Short circuit between sensors. Read explanation → COO Coordinator Clutch pedal sensor The voltage in the clutch pedal sensor circuit has been either above or below the permitted level. Read explanation → ELC Electronically controlled air suspension Front axle solenoid valve. The voltage on the output to the solenoid valve has been too high. Read explanation → ABS Anti-lock Braking System Wheel speed The control unit has detected DC voltage in the signal from the wheel on the left-hand side of the front axle. Read explanation → CUV Visibility system Windscreen washer Too high current consumption on control unit output. The current consumption on the control unit output has exceeded 5 A. On control unit versions with assembly part number 1482564… Read explanation → LAS Locking and Alarm System Extra sensor 2 The voltage on the alarm control unit input has been below 3 V. Read explanation → ACC Automatic Climate Control Reference voltage The reference voltage is too high or too low. Read explanation → ACS Articulation Control System Communication with the EMS control unit Signal from EMS missing. Read explanation → CTR Radio signal Fault in signal to radio unit. Read explanation → CTS CAN communication with the infotainment system (CUI) No CAN messages from the infotainment system. Read explanation →