Scania fault code 1282

EMS Engine Management System Cylinder 2, severe misfire Cylinder 2 is misfiring so much that there is a risk of damage to the catalytic converter. Read explanation → TMS Transmission Management System Solenoid valve for low splitter gear, short circuit Short circuit to 30 voltage in the cable harness for the solenoid valve voltage supply. Read explanation → BMU Battery Management Unit Signal for control-pilot missing The BMU control unit has received an error message during external charging from the CMP control unit (VCCU) concerning the lack of voltage signal between CMP and the pantograph ba… Read explanation → VDT Internal fault Internal memory fault in control unit E754. Read explanation → COO Coordinator Electrically assisted steering (EAS) system Message from the EAS control unit indicates signal fault. Read explanation → MBS Expansion unit B, internal fault The MBS control unit has detected faults in the voltage regulators or communication buses in Expansion unit B. Read explanation → PCS L1 disengage solenoid valve - short to battery Detected by HW. Read explanation → LAS Locking and Alarm System Internal fault The control unit parameters are not set. Read explanation → ALM Control unit, internal fault Fault in the internal memory of ALM control unit. Read explanation → COMMUNICATOR Communicator (C200 / C300 / C400) Digital output 1 is short-circuited to supply voltage The fault code is activated if digital output 1 is short-circuited to supply voltage. A check is carried out each time the system is started. Read explanation → RTT Road Transport Informatics CAN data missing No CAN communication from the vehicle's green CAN bus. The fault code is activated when no CAN data has been received for 30 s and the vehicle speed exceeds 40 km/h. Read explanation → SVIP CAN data missing No CAN communication from the vehicle's green CAN bus. The fault code is activated when no CAN data has been received for 30 s and the vehicle speed exceeds 40 km/h. Read explanation →