Scania fault code 1030

EMS Engine Management System Position sensor for EGR valve T124 EGR valve position sensor T124 is short-circuited to battery. Read explanation → BMU Battery Management Unit Pressure sensor T211, implausibly high pressure Voltage in the pressure sensor circuit is too high. Read explanation → EMD Position sensor for EGR valve T124 EGR valve position sensor T124 is short-circuited to battery. Read explanation → EME Position sensor for EGR valve T124 EGR valve position sensor T124 is short-circuited to battery. Read explanation → EMO Position sensor for EGR valve T124 EGR valve position sensor T124 is short-circuited to battery. Read explanation → VDT Internal fault Opening of the solenoid valve ground connection failed. Read explanation → COO Coordinator Fault in communication with the EBS control unit Signal from the EBS control unit is in status Cannot be executed. Read explanation → MBS Expansion unit C, fault in electric power supply The MBS control unit has detected that the supply voltage to expansion unit C has had an anomalous value. The supply voltage to the expansion unit has been below 16 V. Read explanation → ALM Fault in communication with the bodywork electrical system (BWE) An expected BCS message has failed to arrive. Read explanation → TCC TCC control unit, door lock 1, M6076, open circuit Door lock 1, open circuit in the voltage supply. Read explanation → RTT Road Transport Informatics Hard disk overheated The hard drive is not working. Read explanation → SVIP Hard disk overheated The hard drive is not working. Read explanation →