Scania BCI fault codes
All 216 Scania BCI diagnostic trouble codes, with meaning, causes and how to fix them.
Control units:
BCI B1 (BWEXBUS)BCI C1 (BWEXI)BCI E1 (BWEXA)BCI E1 (BWEXB)BCI E1 (BWEXC)BCI E1 (BWEXD)BCI E1 (BWEXE)BCI E1 (BWEXF)BCI E1 (BWEXG)BCI E1 (BWEXH)BCI E1 (BWEXI)BCI1 (BWE)BCI2 (BWE)BCI3 (BWE)
Showing 181–216 of 216 codes
- 724hex 02D4 High voltage, analogue input signal, expansion unit C (pin 20)
- 725hex 02D5 Low voltage, analogue input signal, expansion unit D (pin 20)
- 726hex 02D6 High voltage, analogue input signal, expansion unit D (pin 20)
- 727hex 02D7 Low voltage, analogue input signal, expansion unit I (pin B8)
- 728hex 02D8 High voltage, analogue input signal, expansion unit I (pin B8)
- 729hex 02D9 Low voltage, analogue input signal, expansion unit I (pin B17)
- 730hex 02DA High voltage, analogue input signal, expansion unit I (pin B17)
- 731hex 02DB Auxiliary heater fuel consumption, signal fault
- 732hex 02DC ODSC unit, communication
- 733hex 02DD Fault reports from the ODSC unit
- 736hex 02E0 Incorrect start configuration
- 737hex 02E1 ODSC unit, GNSS module
- 738hex 02E2 ODSC unit, antenna
- 739hex 02E3 ODSC unit, network module
- 740hex 02E4 ODSC unit, SIM card
- 741hex 02E5 ODSC unit, communication
- 742hex 02E6 Climate system, CAN communication fault
- 743hex 02E7 Programmable switch
- 744hex 02E8 Programmable switch
- 745hex 02E9 Programmable logotype switch, sliding fifth wheel
- 746hex 02EA TMU control unit, contactor, CAN communication fault
- 747hex 02EB Programmable switch, automatic neutral
- 748hex 02EC Inhibit engine start, CAN communication fault
- 749hex 02ED Sensor for the seat on the engine tunnel, short circuit to earth
- 750hex 02EE Sensor for the seat on the engine tunnel, short circuit to voltage supply
- 751hex 02EF Sensor for the seat on the engine tunnel, short circuit to earth
- 752hex 02F0 Sensor for the seat on the engine tunnel, short circuit to voltage supply
- 753hex 02F1 EG power take-off, rotational speed information is not available
- 754hex 02F2 Automatic power shutdown
- 755hex 02F3 Functions are not compatible with control unit hardware
- 756hex 02F4 No CAN message from the body electrical system
- 757hex 02F5 CAN communication with the EMU control unit
- 758hex 02F6 EMU control unit
- 759hex 02F7 Short Circuit to ground for sensor indicating if tipper is fully lowered
- 760hex 02F8 Short Circuit to ground if sensor indicating it tipper is fully closed
- 761hex 02F9 Short Circuit to ground if redundant sensor fully closed