Scania ALLISON DTC 10131 Gear selector position information, incorrect PWM signal

ALLISON Allison automatic gearbox · Scania

Code 10131 (decimal). Some diagnostic tools show it in hexadecimal as 2793.

In short

The control unit has received incorrect information from the drive mode selector via the PWM signal.

Applies to: A4

What does Scania ALLISON fault code 10131 mean?

What causes Scania DTC 10131?

How does the system react?

Sit check sensor lorem circuit dolor unit amet voltage valve ipsum signal sit check sensor lorem circuit dolor unit amet voltage valve ipsum signal sit check sensor lorem circuit dolor unit amet voltage valve ipsum signal sit check sensor lorem circuit dolor unit amet voltage valve ipsum signal sit check sensor lorem circuit dolor unit amet voltage valve ipsum signal sit check sensor lorem circuit dolor unit amet voltage.

How to fix Scania ALLISON fault code 10131?

Read the full explanation with Premium

Causes, system reaction, symptoms and step-by-step repair instructions for every fault code are available to Premium members.

Full explanations of every code and brand
Causes, symptoms and repair steps
New brands and codes included

Get Premium – 7,50 € / month I already have an account

Yearly plan: pay 10 months, get 12. Cancel at any time.

This information is for guidance only. Always follow the manufacturer workshop manual and safety procedures; if in doubt, contact an authorised workshop.